Description:

Flame Stop I-DS is a post-treatment pyrolitic interior/exterior fire retardant penetrates. This product dries clear. This product is highly concentrated and has significant wetting properties. Flame Stop I-DS was designed to penetrate and effectively fire retard open and closed cell structures. When the treated material is subjected to an open flame, the retardant will pyrolitically self-extinguish the fire, with minimal smoke. Flame Stop I-DS is completely non-toxic and non-hazardous to the environment, as well as simple to apply.

Basic Uses:

Flame Stop I-DS is used for interior and exterior applications, such as: open and closed cell foams, foam rubber, nylon netting, exterior composition siding, thatching, bamboo, hardwoods, synthetic fabrics, plastics and many other difficult to penetrate materials.

Advantages:
Class A one coat system. 10 flame spread on Reed Thatching. FAA Certified. Since Flame Stop I-DS penetrates and becomes part of the substrate, the life of the flame retardancy is indefinite, in most cases. All of our products were tested using single-coated materials. Flame Stop I-DS has many uses and is our most concentrated fire retardant. Flame Stop I-DS will not deteriorate because it is not a coating. Instead, it penetrates and becomes part of most materials. This product will not alter the structural integrity of wood. Flame Stop I-DS is often chosen because it is non-toxic, dries clear, and is easy to apply with a sprayer, brush or roller. Once cured (24hrs.), the treated material may be painted with a latex paint.

Limitations:
Do not dilute.
Storage Range: 110 degrees F. to 45 degrees F. Shelf Life: 3 years, if kept within storage temperatures.

Applicable Standards:
Flame Stop I-DS has been tested to the following standards:
ASTM E-84, NFPA 255, UL 723: U.S. Testing Title 4 #LA 63494 (Ether Foam), Omega Point Laboratories #8924-89133 (Reed Thatching) FAR 25.853 (Polyurethane Foam) CA Reg. #C-14401, NFPA 701

Application:
All materials to be treated should be clean. Flame Stop I-DS can be applied as is by spraying or immersing. A small test should be performed by the utilization of a small flame (butane lighter). Hold a 4” x 12 “ piece of the treated material vertically and apply the flame to the lower portion for 10 seconds. Remove the ignition source. The flame must go out within 2 seconds. This test is similar to the small scale NFPA 701 field test. Apply to wood at the rate of 200 square feet per gallon.
****After treatment, a minimum 24 hour conditioning period is necessary before testing****


Warranty
These products are sold on condition that the user will evaluate them to determine their suitability for the user’s intended purpose. Flame Stop, Inc. warrants that each quantity of Flame Stop I-DS will be the kind designated and free of defects. No other warranty is implied, since Flame Stop, Inc. has no control over the application. Additionally, Resistafire, Inc. cannot provide any additional warranty for products which are sold directly to the consumer for do-it-yourself applications, since we would have no control over the application.